We are now happy to offer the new Adjustable Monkey Bars, which can be mounted on almost all bikes in our current lineup (not the Supermarche) as well as the Boda Boda Original and Mundo V3!


In the interest of preserving information, our previous answer is below:


We don't currently have a Monkey Bar for the Boda Boda Original (aka Boda Boda V2 and V1), but it's possible to convert an existing set to fit the shorter deck of the Boda Boda OG:



What you need:

  • Monkey Bars

  • 2 sets of bar tape

  • Pipe Cutter or Bandsaw

  • 9/16 diameter Aluminum (2- 20” sections and 2-15 inch sections) - This is available online from McMaster-Carr supply

  • 6mm or 1/4" drill bit

Outside Support Rods

  1. Cut to size

    1. Remove 335mm from both outside support rods

    2. Discard middle section




        2. Join Together using custom connection rods

                1. Cut two 510mm rod using 9/16” diameter structurally sound steel or aluminum


                2. Insert connection rods into outside support rods

                3. Mark assembly hole location of support rods onto both side of inside rods

                4. Remove connecion rods from outside support rods

                5. Drill 6mm or ¼” holes at each marked location




Inside Support Rods

  1. Cut to size

    1. Remove 335mm from the center of both inside support rods (this is the rod with a hole in the center)

    2. Discard the middle section

  2. Join together using custom connection rods

    1. Measure the distance from the end of the inside to the edge

    2. Add distance together and cut an inside support rod of that size

    3. Repeat for second side

Assembly 

  • Assemble monkey bars using standard monkey bar instructions, but ensure bolt passes through connecting rod holes to pin the assembly

  • Wrap monkey bars with handlebar tape  to protect against sharp edges